- 专业度
- 300
- 元宝
- 662
- 金钱
- 300
- 最后登录
- 2020-5-11
- 注册时间
- 2012-12-8
- 精华
- 0
- 积分
- 1630
- 阅读权限
- 70
- 帖子
- 68
 
TA的每日心情 | 无聊
2015-11-9 10:50:53 |
|---|
签到天数: 23 天 [LV.4]偶尔看看III - 金钱
- 300
- 元宝
- 662
- 专业度
- 300
|
发表于 2014-5-28 14:17:30
|显示全部楼层
本帖最后由 pei 于 2015-9-28 16:00 编辑
日立ARM系列的盘进程序后不认盘不断电退出重进程序能识别到型号和固件版本序列号，但无法识别到容量，固件也无法访问,UDMA提示如下：该如何处理？
Selected family......................... : 7232A7
Model by ID............................. : HGST HTS725050A7E630
Techno mode key......................... : Error
ROM reading...
Possible Tech Key is found. Checking...
Result.................................. : Ok
Error startintg command: Reading SA [0x3F0000004, 0x4]
Device error detected (ABR)
Error startintg command: Reading SA [0x3F0000004, 0x1]
Device error detected (ABR)
Error reading module USAG(0): Error startintg command: Reading SA [0x3F0000004, 0x1]
Device error detected (ABR)
Error startintg command: Reading SA [0x3F0100004, 0x4]
Device error detected (ABR)
Error startintg command: Reading SA [0x3F0100004, 0x1]
Device error detected (ABR)
Error reading module USAG(1): Error startintg command: Reading SA [0x3F0100004, 0x1]
Device error detected (ABR)
Loading modules table................................................. : Error
Error :............................................................... : Module USAG: no copies read!
Loading the table of "open" modules................................... : Error
Error :............................................................... : Error executing loading "open" modules dir command
是否是NV损坏，但ARM系列的盘又没法做NV适配。怎么恢复数据，求助。。。。。。。。。
|
|
