WD5000BMVW砍头

data0531

硬盘信息：
Model : WDC WD5000BMVW-11AMCS0
Serial : WD-WXG1EC0PUV65
Firmware : 01.01A01
Capacity : 465.76 GB (976 773 168)
Techno mode key
Techno mode key......................... : Ok

RAM:
HDD Info reading........................ : Ok
Heads number............................ : 4
Cyl Count............................... : 256

Zone allocation table................... : Ok
SA SPT.................................. : 1098

ROM:
ROM reading............................. : Ok
ROM Data size........................... : 256 Kb
ROM version............................. : 09.0UA
ROM generation.......................... : 09.0UA
Link table version...................... : 02.0L.
Consolidated ROM version................ : 0009000U

ROM Modules:
Flash ROM dir reading................... : Ok
Modules directory address............... : FIXED
SA regions address...................... : by default
Heads configuration..................... : by map
Heads number............................ : 4
Heads number in use..................... : 4
Switched off heads...................... : No
Heads map............................... : 0,1,2,3
ROM Firmware version.................... : 0009000U

Service area:
SA dir reading (ID)..................... : Ok
SA Access............................... : Copy 0,Copy 1

Configuration reading................... : Ok
Master Password......................... : has not been set
User Password........................... : has not been set
Victoria检测结果：遇到坏道的时候硬盘灯的状态有问题

UDMA检测磁头的结果：

发现3头损坏，需要砍掉。

祥云769379864

就是啊！怎么弄呢哪位大哥能说一下呢？

祥云769379864

就是啊！怎么弄呢哪位大哥能说一下呢？

祥云769379864

就是啊！怎么弄呢哪位大哥能说一下呢？

鑫灿维

呵呵呵，的却很厉害呀

data0531

把案例发上来，等答案的

zhongmin

以前的盘，
1步，手工停用译码表
2步，关磁头
3步，编辑P表，把关掉的磁头在P表里面的缺陷删掉，
4步，改LBA值
5步，重建译码表，
6步，FORMAT 全盘，OK搞定
但现在的盘一关头就会敲的，不知道哪个模块要改过来，哪位大侠会?

yI首简单歌

学习了，感谢分享。