PC3000 军达成数据恢复论坛

标题: 日立ARM无法访问固件 [打印本页]

作者: hongfanshuju 时间: 2014-5-28 14:17:30 标题: 日立ARM无法访问固件

本帖最后由 pei 于 2015-9-28 16:00 编辑

日立ARM系列的盘进程序后不认盘不断电退出重进程序能识别到型号和固件版本序列号，但无法识别到容量，固件也无法访问,UDMA提示如下：该如何处理？
Selected family......................... : 7232A7
Model by ID............................. : HGST HTS725050A7E630

Techno mode key......................... : Error
ROM reading...
Possible Tech Key is found. Checking...
Result.................................. : Ok

Error startintg command: Reading SA [0x3F0000004, 0x4]
Device error detected (ABR)
Error startintg command: Reading SA [0x3F0000004, 0x1]
Device error detected (ABR)
Error reading module USAG(0): Error startintg command: Reading SA [0x3F0000004, 0x1]
Device error detected (ABR)
Error startintg command: Reading SA [0x3F0100004, 0x4]
Device error detected (ABR)
Error startintg command: Reading SA [0x3F0100004, 0x1]
Device error detected (ABR)
Error reading module USAG(1): Error startintg command: Reading SA [0x3F0100004, 0x1]
Device error detected (ABR)
Loading modules table................................................. : Error
Error :............................................................... : Module USAG: no copies read!
Loading the table of "open" modules................................... : Error
Error :............................................................... : Error executing loading "open" modules dir command

是否是NV损坏，但ARM系列的盘又没法做NV适配。怎么恢复数据，求助。。。。。。。。。

欢迎光临 PC3000 军达成数据恢复论坛 (http://www.jundacheng.com/bbs/)